Question by nines_rodriguez: Injection moulding assembly?
If these are the assembly spec:- Mould expense £2k. – Clamping-force 50 kN. – Width between necktie-bars 300 mm. – Melt force on introduction 20 MPa. – Shot perimeter 7 g. – Running cost £.01 /min. – Cycle clip 1 Min.And I neediness to do 750,000 small plastics discs (10 mm radius and 5 g mass), what is the disbursal per point when victimization the section assembly, if somebody could Archer me how to wash it putout it’d be a big assistance, cheer.oh and the assembly has a 2 baffle mould with single pit if that aid!All I’m precondition is what’s section, don’t advisement you demand to payoff thing else into relationship.
Best reply:
Answer by Toledo Engineer
You listed the run expense, which i would issue to expectation galvanism and annualized upkeep cost, but what about the others? Material disbursement? The Engineering Cost for design the component? Labor expense? Someone has to tally the assembly and sustenance it run. Someone has to apparatus the dice and return it run correctly.
Give your reply to this interrogation below!…